It's a pager and a radio!! $429 VHF $424 UHF $505 VHF Voice storage and Vibrate $500 UHF Voice storage and Vibrate Includes battery, antenna, and charger. Frequency range 136-174 MHz  VHF 400-470 450-512 UHF Number of Channels Max. 128 channels/ 8 zones Channel spacing 12.5/25kHz Antenna impedance 50 Ω (SMA Type) Frequency error ±2.5ppm PLL channel step 2.5/3.125Khz Power supply requirements 7.2V DC Current drain (approx.) Transmit   Receive   5W 1W AF max.   Stand-by 1.8A 0.7A 500mA (Internal speaker) 350mA (External Speaker) 85mA Operating temperature range –30°C to +60°C –22°F to +140°F Dimensions (W x H x D) (projections not included) 56 × 97 × 36.4mm 27⁄32 × 313⁄16 × 17⁄16 in. Weight (approx.) 280g; 9.9oz (With BP-227) Transmitter Output power 5.0W Modulation system Variable reactance frequency modulation Max. frequency deviation ±5kHz (wide) ±2.5kHz (narrow) Modulation limiting 60-100% of Max. deviation Audio harmonic distortion 3% typ. (AF 1kHz, 40% deviation) Spurious emissions 70dB typ. Adjacent channel power 70dB Min. (wide) 60dB Min. (narrow) FM Hum and Noise 46dB typ. (wide) 40dB typ. (narrow) External microphone impedance 9-pin multi connector/2.2kΩ Receiver Sensitivity 0.25µV typ. (at 12db SINAD) Squelch sensitivity 0.25µV typ. (at threshold) Adjacent channel selectivity 75dB typ. (wide) 65dB typ. (narrow) Spurious response 70dB Intermodulation 74dB typ. Hum and noise 45db typ. (wide) 40dB typ. (narrow) Audio output power 0.7W typ. (Internal speaker) 0.5W typ. (external speaker) at 5% distortion with an 8Ω load External SP connector 9-pin multi connector/8Ω Applicable U.S. Military Specifications Icom makes rugged products that have been tested to and passed the following MIL-STD requirements and Ingress Protection standards. Standard MIL 810 C MIL 810 D MIL 810 E MIL 810 F Method Proc Method Proc Method Proc Method Proc Low Pressure 500.1 I 500.2 I, II 500.3 I, II 500.4 I, II High Temp. 501.1 I 501.2 I, II 501.3 I, II 501.4 I, II Low Temp. 502.1 I 502.2 I, II 502.3 I, II 502.4 I, II Temp. Shock 503.1 I 503.2 I 503.3 I 503.4 I Solar Radiation 505.1 I 505.2 I 505.3 I 505.4 I Rain 506.1 I, II 506.2 I, II 506.3 I, II 506.4 I, II Humidity 507.1 I, II 507.2 II, III 507.3 II, III 507.4 – Salt Fog 509.1 I 509.2 I 509.3 I 509.4 – Dust 510.1 I 510.2 I 510.3 I 510.4 I Vibration 514.2 VIII, X 514.3 I 514.4 I 514.5 I Shock 516.2 I, II, V 516.3 I, IV 516.4 I, IV 516.5 I, IV Ingress Protection Standard Dust & Water IP67 (Dust-tight and waterproof protection) Measurements made in accordance with EIA-152C/204D, TIA-603. All stated specifications are subject to change without notice or obligation. Supplied Accessories Antenna (Length may differ according to version) Alligator-type belt clip, MB-98 Battery pack, BP-227

Vibration alert function When a pre-programmed 2-tone/5-tone code or call from a specific user (MDC mode only) is received, the radio vibrates powerfully enough to be felt through heavy clothing. 8 minute voice recorder When a pre-programmed 2-tone/5-tone code or a SelCall (MDC mode only) is received, the voice recorder automatically starts recording the incoming message. You will not miss an important call even when you are temporarily away from the radio. You can manually start recording incoming calls and also your own message. It records up to a maximum of 8 minutes (Or up to 48 calls of 10 sec. recording time). 700mW audio output The IC-F50V delivers a loud 700mW* audio output with the built-in BTL amp. The built-in audio compander provides clear, low noise communications. Improved bass characteristics also betters the audio quality. * Typical with internal speaker. Lone worker function for remote check in When the radio is not operated for a preset period (1 to 255 min.), the radio sounds a beep and requires you to push the emergency button. If the emergency button is not pushed for a preset time (1 to 255 sec.), an emergency signal automatically transmits and informs your co-worker or dispatcher that something may have happened to the individual worker. IP67, dust-tight and waterproof protection The IC-F50V has outstanding protection against dust and water that is equivalent to IP67. The IC-F50V can withstand submersion in 1m depth of water for up to 30 minutes and has dust-tight construction that prevents the ingress of dust. Most popular signalings built-in Use the built-in CTCSS, DTCS, 2-Tone, 5-Tone and MDC signaling capabilities to set up your talk group or selective calling. The IC-F50V can decode ten 2-Tone codes or eight 5- Tone codes on a channel. When a matched tone is received, the following actions are programmable for each code. Bell icon  Answer back call  Beep sound  Auto transmit  Radio Stun/Kill/Revive  Voice recorder Vibration alert MDC 1200 Compatible The following selective calling and ANI features are available with the built-in MDC signaling. PTT ID Radio check Caller ID Call alert SelCall Emergency, emergency mic monitoring 500 Aliases Status/message Radio stun/revive Mode dependent scan In the mode dependent setting, the scanning setting is dependent on the operating channel. When you change the operating channel, the scanning list automatically changes to the operating channel setting. It is convenient when you move to a different operating area and change an operating channel, you don’t have to change the scanning setting. Enhanced scanning The Tx channel while scanning can be programmed per scanning list. The talk back function allows you to transmit on the channel detected after scanning resumes after a preset time, prior to the Tx channel setting. The nuisance delete function temporarily deletes a busy channel from the scanning list. Backlight at stop scan automatically turns on the LCD backlight when the scan stops. Compact body 56(W)×97(H)×36.4(D) mm* compact body with durable, dependable construction, has been tested to MIL standard specifications. * 27⁄32(W)×313⁄16(H)×17⁄16(D) in Li-Ion battery pack The large capacity 1700mAh Lithium-Ion (Li-Ion) battery pack, BP-227 provides a practical 9–10 hours* of operating time. * Typical operation Tx:Rx: Stand-by=5:5:90 Other features 128 memory channels with 8 zones Inversion type*1 voice scrambler built-in Optional VOX headsets available Optional GPS speaker-microphone Power ON password Radio stun/kill/revive 8 DTMF autodial Normal and priority scans 2-step power saver and 2-step low battery beep BIIS 1200 mode programmable Busy, repeater lockout functions BTL only version (no vibration alert and no voice recorder) and BTL/Vibration alert version (no voice recorder) available*2 and more... *1 Inversion type voice scrambler is not compatible with UT-109/UT-110 voice scrambler.    UT-109/UT-110 cannot be physically installed into the IC-F50V. *2 Not available in some countries. (Not available in the U.S.)